AGA COMPANION Manuel de service télécharger pdf (Page 9)

This cooker can be installed with an approved appliance flexible connection. Supply piping

should not be less than R 1/2 (1/2” BSP). Connection is made to the R 1/2 (1/2” BSP) female

threaded entry in the inlet block located just below the hotplate level on the rear left hand side of

the cooker.

Check for gas soundness after connecting the gas supply.

The gas bayonet connector must be fitted in the shaded area indicated in Fig. 3 . Take into

account that it must be possible to pull the cooker forward sufficiently. Ensure flexible hose is not

trapped between electrics cover and rear wall. Ensure hose is routed within shaded area, and

away from shielded oven vent.

The flexible hose must be in accordance with the relevant standards.

NOTE: FOR L.P.G. APPLIANCE

The flexible hose must be suitable for use with Propane gas, capable of 70°C temperature rise,

and carry a red stripe, band or label. If in doubt contact your supplier.

CONNECTING TO GAS

Fig. 3

DESN 511751

480

390

200

460

573

279

558

TERMINAL BLOCK

COVER

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 27 28

Pas de commentaire

AGA COMPANION Manuel de service Page 9