AGA Ludlow Wood Burning Instructions d'exploitation télécharger pdf (Page 3)

LUDLOW WOOD FUEL NON-BOILER STOVE

INSTALLATION & OPERATING INSTRUCTIONS

GENERAL

When installing, operating and maintaining your

stove respect basic standards of fire safety. Read

these instructions carefully before commencing the

installation. Failure to do so may result in damage to

persons or property. Consult your local Municipal

office and your insurance representative to deter-

mine what regulations are in force. Save these

instructions for future reference.

Special care must be taken when installing the stove

such that the requirements of the Health & Safety at

Work Act are met.

Handling

Adequate facilities must be available for loading,

unloading and site handling.

Fire Cement

Some types of fire cement are caustic and should

not be allowed to come into contact with the skin. In

case of contact with the skin wash immediately with

plenty of water.

Asbestos

This stove contains no asbestos. If there is a possi-

bility of disturbing any asbestos in the course of

installation then please seek guidance and use

appropriate protective equipment.

Metal Parts

When installing or servicing this stove care should

be taken to avoid the possibility of personal injury.

NOTE: Please note that it is a legal requirement

under England & Wales Building Regulations that

the installation of the stove is either carried out

under Local Authority Building Control approval or

is installed by a Competent Person registered with

a Government approved Competent Persons

Scheme. HETAS Ltd operate such a Scheme and

a listing of their Registered Competent Persons

can be found on their website at www.hetas.co.uk.

IMPORTANT WARNING: This stove must not be

installed into a chimney that serves any other

heating appliance. There must not be an extrac-

tor fan fitted in the same room as the stove as

this can cause the stove to emit fumes into the

room.

THE CLEAN AIR ACT 1993 AND SMOKE

CONTROL AREAS

Under the Clean Air Act local authorities may

declare the whole or part of the district of the author-

ity to be a smoke control area. It is an offence to emit

smoke from a chimney of a building, from a furnace

or from any fixed boiler if located in a designated

smoke control area. It is also an offence to acquire

an "unauthorised fuel" for use within a smoke control

area unless it is used in an "exempt" appliance

("exempted" from the controls which generally apply

in the smoke control area).

PRE-INSTALLATION ASSEMBLY

1. After removing the stove from the packaging,

open the fire door and remove all contents from

inside.

2. Fit the fire door handle using the screw provided.

3. Remove the stove from the pallet and fit the legs.

Position it in the final installation position (See

Location & Clearance to Combustibles Section).

FLUES

Flues should be vertical wherever possible and

where a bend is necessary, it should not make an

angle of more than 45

with the vertical. Horizontal

flue runs should be avoided except in the case of a

back outlet from the appliance, when the length of

the horizontal section should not exceed 150mm.

In order to minimise flue resistance and to make

sweeping easier it is recommended to use 2 x 45

bends rather than a 90

bend.

The flue termination point must be located to min-

imise any wind effects. Wind effects of suction,

pressure zones and turbulence can be created by

the roof and adjacent objects. Wind effects can also

be created by natural land contours.

The installation must be completed in accor-

dance with current National and European

Standards and Local Codes. It should be noted

that the requirements and these publications

may be superseded during the life of this man-

ual.

1 2 3 4 5 6 7 8 ... 12 13

Commentaires sur ces manuels

Pas de commentaire

AGA Ludlow Wood Burning Instructions d'exploitation Page 3

Commentaires sur ces manuels

Produits connexes et manuels pour Cuisiniers AGA Ludlow Wood Burning