AGA ADC3EHEA Guide d'installation télécharger pdf (Page 10)

1. Fit the handrail bracket over the fixing stud located on the top plate. Lock into position by

tightening the grub screw nearest the appliance. (See Fig. 5).

Fig. 5 DESN 516883

AGA DC3 HANDRAIL CONNECTION

2. Next the handrail, endcaps and handrail require assembly.

Slide the handrail through the handrail brackets.

Fig. 6 DESN 516880

AGA DC3 HANDRAIL CONNECTION

3. Once the handrail assembly is located squarely, lock the handrail in position by winding in

the grub screws on the underside of each handrail bracket.

4. Once the handrails are locked in position, fit the handrail endcaps. The endcaps should be

carefully pushed into place until they sit flush with the outside face of each bracket (a light

smear of lubricant such as, washing up liquid on the end cap ‘O’ rings may ease fitment.

5. Finally, fit the plinth facia to the magnets on the front of the plinth. Make sure that the

plinth facia is centrally located and does not overhang the range.

Commission the AGA Dual Control, as stated in the relevant Installation Instructions and carry

out functional test on each of the features of the AGA Dual Control.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Pas de commentaire

AGA ADC3EHEA Guide d'installation Page 10