AGA AMPROTTDWSS Guide de l'utilisateur télécharger pdf (Page 30)

To add rinse aid, turn the dispenser

cap to “Re

ll” and lift o . Pour rinse

aid into the opening until the

indicator level is at “Full.” Replace

the dispenser cap and turn to

“Lock.” Make sure cap is fully

locked.

NOTE: For most water conditions, the factory setting will give good

results.

Check the water hardness level to ensure no rings or spots on

your dishware before adding rinse aid or adjusting the factory

setting.

If you have hard water or notice rings or spots, try a higher

setting.

Turn the arrow adjuster inside the

dispenser by either using your

gers or inserting a at-blade

screwdriver into the center of the

arrow and turning.

Select a Cycle (cycles vary by model)

See “Cycle and Option Descriptions” charts in the following

section.

Heavier cycles and options a

ect cycle length.

Select Options (options vary by model)

See “Cycle and Option Descriptions” charts in the following

section.

You can customize your cycles by pressing the options desired.

Start or Resume a Cycle

Run hot water at the sink nearest your dishwasher until the

water is hot. Turn o

water. For best dishwashing results, water

should be 120ºF (49ºC) as it enters the dishwasher.

For models with controls on top of the door, select

wash cycle, option and press START/RESUME

before closing the door. Push door

rmly closed.

The door latches automatically. Select the wash

cycle, options and press STAR/RESUME or press

START/RESUME to repeat the same cycle and

options as in the previous wash cycle.

You can add an item anytime at the beginning of the cycle.

Open the door slowly and add the item. Close the door

Press START/RESUME.

Lock

Refill

STEP 3

STEP 4

¹⁄

turn to lock

TOP RACK

WASH

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 80 81

Commentaires sur ces manuels

Pas de commentaire

AGA AMPROTTDWSS Guide de l'utilisateur Page 30

Commentaires sur ces manuels

Produits connexes et manuels pour Lave-vaisselle AGA AMPROTTDWSS